VPC i2 MICRO iCON User Manual page 12

i2 MICRO iCON USER'S MANUAL: SECTION 7
i2 MICRO iCON ACCESSORIES ● i2 MICRO iCON RECEIVER STRAIN RELIEF ASSEMBLY
TOOLS REQUIRED
Phillips Head Screwdriver
ASSEMBLY INSTRUCTIONS
1. Using the Phillips head screwdriver, fasten the strain relief to
the back (wiring) side of the i2 Micro iCon receiver with the
2-56 screws and nuts provided (Figure A). Place the nuts in
the keying positions from the front side of the receiver.
NOTE: If using the keying features, replace the 2-56 nuts with the
keying pins (Figure B).
2. Torque screws to 2 in-lbs [0.23 Nm].
NOTE: Four wiring ties are included with the strain relief for
restraining wires.
7-1
PART # 310 113 559
For the most current information available, visit www.vpc.com
VIRGINIA PANEL CORPORATION
Figure A. i2 Micro iCon receiver strain relief.
Figure B. i2 Micro iCon receiver strain relief with keying pins.
4/23/15