VPC i2 MICRO iCON User Manual page 21

i2 MICRO iCON USER'S MANUAL: SECTION 9
ITA frame is not lined up when in the process of engagement with receiver
This may indicate that the ITA is out of alignment or that a module is not mating with its intended mate.
• Remove and inspect the ITA for alignment.
• Check for foreign objects/tools.
• Inspect the matching of modules - Signal ITA Module to mate with Signal Receiver Module, etc.
• The keying pin locations do not mate.
• The engagement knob is installed incorrectly.
9-1
TROUBLESHOOTING
Forceful engagement of the Receiver and the ITA
will result in serious damage to multiple parts of the
system (modules, receiver, ITA and contacts)!
For the most current information available, visit www.vpc.com
VIRGINIA PANEL CORPORATION
4/23/15