VPC i2 MICRO iCON User Manual page 16

i2 MICRO iCON USER'S MANUAL: SECTION 8
84 PIN HEADER, PART # 510 109 204 • 60 PIN HEADER, PART # 510 109 206
TOOLS REQUIRED
Phillips Head Screwdriver
ASSEMBLY INSTRUCTIONS
1. Assemble two headers to the PCB. See next page for
recommended PCB layout.
NOTE: To ensure a secure connection without damaging the
PCB, the board must be properly supported between the
mounting holes to distribute pressure evenly. Otherwise, the
insertion force may be high enough to damage or break the
board. Reference VPC part # 910 121 199 if a tool is needed.
2. Using the Phillips head screwdriver, secure the headers and
mounting bracket (Part # 310 113 562) to the PCB using the
supplied 2 mm screws (Figure A).
Secure the receiver to the mounting panel (Figure B) following
3.
the recommended panel cutout (see Section 3).
4. Using the Phillips head screwdriver, press the PCB and headers
onto the receiver and secure the mounting bracket to the
receiver using the supplied captive 2-56 screw (Figure C).
Figure B. Secure receiver to mounting panel.
8-1
i2 MICRO iCON PCB ASSEMBLY
MOUNTING BRACKET, PART # 310 113 562
For the most current information available, visit www.vpc.com
VIRGINIA PANEL CORPORATION
Figure A. Secure headers and mounting bracket to PCB.
Figure C. Secure mounting bracket to receiver.
4/23/15