VPC i2 MICRO iCON User Manual page 11

i2 MICRO iCON USER'S MANUAL: SECTION 6
TOOLS REQUIRED
Phillips Head Screwdriver
Flat Blade Screwdriver
RECEIVER INSTRUCTIONS
Remove strain relief or keying pins (Section 7) if needed.
1.
2. Using the Phillips head screwdriver, remove the four panel
mounting screws from the top and bottom of the receiver
(Figure A).
3. Using the flat head screwdriver, remove the two flat head
assembly screws from the back of the receiver (Figure A).
4. Insert the flat blade screwdriver into the slot on the top
of the receiver and pry the end of the receiver using a
twisting motion until visible separation is indicated. Repeat
on the opposite end of the receiver.
5. Grasp the receiver halves and apply force in opposite
directions, rocking the ends of the receiver while slightly
pulling the front of the receiver away from the mating
back section. Be sure to open both sides of the receiver
simultaneously or contacts could be damaged.
6. Extract the signal contact per the QuadraPaddle Users
Manual. Reference Contact Part # 610 138 200 for
Receiver Part # 310 130 101 or Contact Part # 610 138 216
for Receiver Part # 310 130 102.
For Hybrid Receivers (Part #s 310 130 104 or 310 130 105):
7. Extract the power contact per the Micro Power Users
Manual. Reference Contact Part # 610 142 101.
8. Extract the coaxial contact per the Micro Coaxial Users
Manual. Reference Contact Part # 610 140 XXX.
ITA INSTRUCTIONS
1. Refer to Section 4 for ITA Cover Removal Instructions.
2. Extract the signal contact per the QuadraPaddle Users
Manual. Reference Contact Part # 610 138 109 or 610 138
112.
For Hybrid ITA (Part # 410 130 104):
3. Extract the power contact per the Micro Power Users
Manual. Reference Contact Part # 610 143 101.
4. Extract the coaxial contact per the Micro Coaxial Users
Manual. Reference Contact Part # 610 141 XXX.
6-1
i2 MICRO iCON CONTACT REMOVAL
PART # 310 130 XXX, 410 130 XXX
For the most current information available, visit www.vpc.com
Panel Mounting
Screws
Figure A. i2 Micro iCon Receiver separation.
Panel Mounting
Screws
Figure B. i2 Micro iCon Hybrid Receiver separation.
VIRGINIA PANEL CORPORATION
Assembly
Screws
Assembly
Screws
4/23/15