VPC i2 MICRO iCON User Manual page 15

i2 MICRO iCON USER'S MANUAL: SECTION 7
i2 MICRO iCON ACCESSORIES ● KEYING PIN KIT, RECEIVER AND ITA ASSEMBLY
The iSeries keying kit includes two pins and screws
which provide six different keying options. The i2
Micro iCon system is designed to accept two kits
which increase the keying options to 36.
TOOLS REQUIRED
Phillips Head Screwdriver
ASSEMBLY INSTRUCTIONS
Determine the keying pin's desired orientation (Figure A).
1.
2. Using a Phillips head screwdriver, secure a keying pin in
the i2 Micro iCon receiver with the 2-56 screws provided
with the receiver (Figure B). Torque screws to 2 in-lbs [0.23
Nm].
NOTE: If the strain relief plate, Part # 310 113 559, is being
used, replace the screws used to secure the keying pins
with the screws included with the strain relief plate.
3. Remove the ITA cover (see Section 4).
4. Using a Phillips head screwdriver, secure a keying pin
in the i2 Micro iCon ITA with the 2-56 screws provided
(Figure C). Torque screws to 2 in-lbs [0.23 Nm].
5. Replace the i2 Micro iCon ITA cover (see Section 4).
Figure B. i2 Micro iCon receiver with keying pins.
7-4
PART # 310 113 461
For the most current information available, visit www.vpc.com
VIRGINIA PANEL CORPORATION
Figure A. i2 Micro iCon receiver and ITA mating faces. In order to
mate the connector, the keying pin must be in the same numeric
position in both the receiver and ITA.
Figure C. i2 Micro iCon ITA with keying pins.
4/23/15