Connection For Turn Signals Activation; Standard Connections; Connections For Vehicles With Separate Lines; Connection To Hazard Light Switch - Gemini 933 Series Installation And Use Manual

7.0 - C ONNECTION FOR TURN SIGNALS ACTIVATION

7.1 - STANDARD CONNECTIONS

LEFT TURN
INDICATOR
ORANGE
GEMINI 933
ORANGE
SYSTEM
WHITE-ORANGE
WHITE-ORANGE wire must ONLY be
connected if the system is to operate
through turn indicators.

7.2 - CONNECTIONS FOR VEHICLES WITH SEPARATE LINES

WHITE-ORANGE wire must ONLY be
connected if the system is to operate
through turn indicators.
WHITE-ORANGE
ORANGE
GEMINI 933
SYSTEM
ORANGE
2A diodes

7.3 - CONNECTION TO HAZARD LIGHT SWITCH

GEMINI 933
SYSTEM
PAGE 08 - INSTALLER MANUAL
RIGHT TURN
INDICATOR
TURN INDICATORS
CONTROL UNIT
Front Side Rear Rear
LH LH LH RH
Add 6
Select "optical pulse signals"
in the "SYSTEM
PROGRAMMING" menu.
Do not make this connection
if the system is to operate
BLUE
through the turn indicators.
VEHICLE
ELECTRICAL
CIRCUIT
The 933 system can operate in various modes according to the vehicle on which it is installed and the
available connections (refer to the vehicle installation specifications).
The alarm system can be managed via the vehicle CAN BUS line and operate in combination with the
CAN signals, with the turn indicators flashes and/or the door lock motor unit. The system automatically
manages the different arming/disarming signals.
The various arming modes are listed below and the connections indicated in the following paragraphs.
!
Arming via
!
Arming via door lock motor unit
!
Arming via turn indicators flashes
!
Arming via turn indicators flashes and locking motors
!
Arming via turn indicators flashes, locking motors and
System arming/disarming and alarms are managed via CAN. t
CAN wires to the vehicle CAN line
www.gemini-alarm.com).
System arming/disarming connections must be made to the vehicle door lock motor unit (polarity
inversion).
! If the turn indicators lock/unlock flashes are identical, connect the door lock motors.
Side Front
RH RH
If the turn indicators flash when unlocking with the car mechanical key, do not make this
!
To armi/disarm the system, connect the WHITE-ORANGE wire to a wire of the turn indicators.
This type of connection allows the system to operate through the CAN BUS line with the turn indicators
or the door lock motor unit or both.
The system automatically manages the different lock/unlock signals according to the programming
and the connections made.

8.0 - CONNECTIONS TO ARM/DISARM THE SYSTEM

CAN BUS line.
.
.

8.1 - CONNECTIONS AND MANAGEMENT VIA CAN BUS LINE

(see available diagrams on our website reserved area:
8.2 -

CONNECTIONS TO DOOR LOCK MOTOR UNIT

8.3 - CONNECTIONS TO TURN INDICATORS

connection.

8.4 - COMBINATION CONNECTION

.
CAN BUS line.
herefore only connect the alarm system
INSTALLER MANUAL - PAGE 09