Table of Contents
Advertisement
10.0 - C
ONNECTIONS FOR TURN INDICATORS ACTIVATION
10.1 - STANDARD CONNECTIONS
LEFT TURN
INDICATOR
ORANGE
GEMINI
ORANGE
931R12
WHITE-ORANGE
SYSTEM
WHITE-ORANGE wire must ONLY be
connected if the system is to operate
through turn indicators.
10.2 - CONNECTIONS FOR VEHICLES WITH SEPARATE LINES
WHITE-ORANGE wire must ONLY be
connected if the system is to operate
through turn indicators.
WHITE-ORANGE
ORANGE
GEMINI
931R12
SYSTEM
ORANGE
10.3 - CONNECTION TO HAZARD SWITCH
GEMINI
931R12
SYSTEM
PAGE 10 - INSTALLER MANUAL
RIGHT TURN
INDICATOR
TURN INDICATORS
CONTROL UNIT
Front
Side
Rear
Rear
Side
LH
LH
LH
RH
Insert six
2 Ampere
diodes
Select "optical pulse signals"
in "SYSTEM
PROGRAMMING" menu.
Do not make this connection
if the system is to operate
BLUE
through turn indicators.
VEHICLE
ELECTRICAL
SYSTEM
The 931R12 system can operate in various modes according to the vehicle on which it is installed and
connections that can be made.
The alarm system can be managed via the vehicle CAN-BUS line and operate in combination with the
turn indicator flashes and/or the door lock motor units. The system automatically manages the
different arming/disarming signals.
Refer to the installation specifications for the available connections for each vehicle.
The various arming modes are listed below and the connections indicated in the following paragraphs.
!
A
rming via
!
Arming via door lock motor units
!
Arming via turn indicators flashes
!
Arming via turn indicators flashes and door lock motor unit
!
Arming via turn indicators flashes, door lock motor unit and
System arming/disarming and alarms being managed via CAN-BUS line,
BUS wires to the vehicle CAN line
System arming/disarming connections must be made to the vehicle door lock motor unit (polarity
inversion
).
!
Front
RH
RH
If the turn indicators flash when unlocking with the car mechanical key, do not make this
!
To arm/disarm the system, connect the WHITE-ORANGE wire to a wire of the turn indicators
This type of connection allows the system to operate via the CAN BUS line with the turn indicators or
the door lock motor unit or both.
The system will automatically manage the different lock/unlock signals according to the programming
and the connections made.
11.0 - CONNECTIONS TO ARM/DISARM THE SYSTEM
CAN-BUS line.
.
.
11.1 - CONNECTIONS AND MANAGEMENT BY CAN-BUS LINE
(see available diagrams at: www.gemini-alarm.com).
11.2 -
CONNECTIONS TO DOOR LOCK MOTOR UNIT
11.3 - CONNECTIONS TO TURN INDICATORS
If the turn indicators lock/unlock flashes are identical, connect the door lock
motor unit.
connection.
11.4 - "COMBINATION" CONNECTION
.
CAN-BUS line.
only connect the alarm CAN
.
INSTALLER MANUAL - PAGE 11
Advertisement
Table of Contents
