Geeetech Delta Rostock mini G2 pro Building Instructions page 88

ShenZhen GETECH CO.,LTD
GEEETECH
addressed.
 Frame is stable and correctly aligned.
 Rods are correctly aligned
 Belts are taut.
 Driving wheel turns smoothly
 Bed is level in relation to the path of the extruder.
 Filament rolls freely from the spool, without causing too much tension on the
extruder.
 Current for stepper motors is set to the correct level.
 Wires are correctly connected
 Couplings and pulleys are fixed tightly
Firmware settings are correct including: axis movement speeds and acceleration;
temperature control; end-stops; motor directions.
Extruder is calibrated in the firmware with the correct steps per mm of filament.
The point regarding the extruder step rate is vital. Slic3r expects that the machine will
accurately produce a set amount of filament when told to do so. Too much will result
in blobs and other imperfections in the print, too little will result in gaps and poor
inter-layer adhesion.
www.geeetech.com Tel: +86 755 2658 4110 Fax: +86 755 2658 4074 - 858
88