Geeetech Delta Rostock mini G2 pro Building Instructions page 31

SCS10UU
Linear Bearing
M3x8mm Screw
M3x12mm Screw
M5x16mm Screw
M3x40mm Screw
Spring
M3 washer
rod-end bearing
holder
Step1. Fix the belt mount on the A12 with 2 M3 x12 screws and washer.
Step2. Fix the Endstop trigger mount on the other side of the A12 with 2 M3 x 12mm
screws and washer.
Step3. Connect the diagonal rod joint and the SCS10UU linear bearing with the A12
in between. Fix it up with 8 M5x16mm screws.
Note the direction of the diagonal rod joint, the wider edge is near the Endstop trigger
mount.
www.geeetech.com
ShenZhen GETECH CO.,LTD
GEEETECH
NO.35 6
NO.18 6
NO.19 12
NO.27 24
NO.23 3
NO.29 3
NO.5 24
NO.3 6
Tel: +86 755 2658 4110 Fax: +86 755 2658 4074 - 858
31