Lutron Electronics HomeWorks Protocol Manual page 77

SETLED
SETLEDS
Syntax
SETLEDS, <address>, <led states>
Parameter Description
address system address of the keypad
states to set some or all the LEDs
led states
LED #1 is the left most LED in the string
Description
Sets the states of several keypad leds. If the designated leds are already programmed to
indicate the status of something else in the system, this command will have no effect on the led
state.
Example
Turn on LED #3 & LED #10 on processor 2, link 5, keypad address 7
L232> SETLEDS, [2:5:7], xx1xxxxxx1
Example
Turn off LED #1 and flash LEDs #11 to #15 on processor 1, link 6, keypad address 4
L232> SETLEDS, [1:6:4], 0xxxxxxxxx22222
See Also
RKLS - Request keypad led states
http://www.lutron.com/hwi/Help/l232/setleds.htm [7/3/03 1:20:02 PM]
Set the LED States for a
Whole Keypad
Format
[processor : link : address]
see device address formatting
description
0 = Off
1 = On
2 = Flash 1
3 = Flash 2
x = Don't change