Lutron Electronics HomeWorks Protocol Manual page 54

FADEDIM
FADEDIM
Syntax
FADEDIM, <intensity>, <fade time>, <delay time>, <address 1>, ..., <address n>
Parameter Description
intensity target intensity for specified dimmer
fade time time for dimmers to fade from current
intensity to target intensity
delay time time for dimmers to delay before starting
to fade
address system address of dimmer to fade
Description
Fades one or more system dimmers to a target intensity using a specified fade time and after a
specified delay time.
Example
Fade processor 1, link1, MI address 0, RPM module 2, zone 3 and processor 2, link 4, D48
address 1, Vareo Bus 4, Vareo address 1 to 100% with a 1 second fade time and a 2 second
delay time
L232> FADEDIM, 100, 1, 2, [1.1.0.2.3], [2.4.1.4.1]
See Also
FLASHDIM - Flash a system dimmer
STOPFLASH - Stop flashing a system dimmer
RAISEDIM - Raise a system dimmer
LOWERDIM - Lower a system dimmer
http://www.lutron.com/hwi/Help/l232/fadedim.htm (1 of 2) [7/3/03 1:19:54 PM]
Fade a dimmer
Format
0 - 100 (percent)
HH:MM:SS
example: 00:00:05 for 5 seconds
see time formatting
if omitted, time defaults to 0 seconds
HH:MM:SS
example: 00:00:05 for 5 seconds
see time formatting
if omitted, time defaults to 0 seconds
[processor : link : address]
maximum of 10 address per command
see device address formatting
description
description
description