Lutron Electronics HomeWorks Protocol Manual page 61

Dimmer Button Press
DBP
Syntax
DBP, <address>, <button number>
Parameter Description
address system address of the H48 or RF
dimmer/switch
button button number to press
number
Description
Simulates the press action of the tap switch for an H48 or RF dimmer/switch. This will affect the
local load and activate any keypad-like press programming. This does not simulate a true
keypad button press that is followed by an immediate release or a delayed hold and release.
This does not simulate the press action of the tap switch for a D48 dimmer/switch. This does
not simulate the press action of the raise/lower rocker for any dimmer.
Example
Press H48 tap switch on processor 1, link 4, router 1, bus 3, dimmer 2.
L232> DBP, [1:4:1:3:2], 1
Press RF tap switch on processor 1, link 8, dimmer address 54. (The device type is 1 for all RF
dimmers/switches.)
L232> DBP, [1:8:1:54], 1
See Also
DBDT - Dimmer button double tap
http://www.lutron.com/hwi/Help/l232/dbp.htm [7/3/03 1:19:57 PM]
Dimmer Button Press
Format
see device address formatting
description
1