Lutron Electronics HomeWorks Protocol Manual page 18

Command Formatting
Command Formatting
All commands are in ASCII characters.
Each command is made up of fields, seperated by commas, and terminated with a carriage return
<CR> = $0D Hex.
Spaces are ignored, allowing for visual formatting of commands
Where letters are used, case is ignored
Some commands allow parameters to be omitted, and a default value will be used. In this case, the
delimiting commas must still be used
There is a limit of 255 characters per command.
http://www.lutron.com/hwi/Help/l232/command_formatting.htm [7/3/03 1:19:41 PM]