Factory Test Menu - ALLIANCE Speed Queen Programming

HF
PO1
PO2
PO3
SFT
DB

Factory Test Menu

Figure 37
If enabled (refer to Globals Menu), the Factory Test Menu allows
the user to run a diagnostic test cycle. The control must be in
Ready Mode.
At the start of the factory test cycle, the control enters Factory
Test Mode. The command message at the bottom of the Factory
Test Menu display will show the remaining step time or prompt
the user for input throughout the test cycle. Refer to Table 21 for
test sequence.
When in Factory Test Mode the
to the next test step.
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
Outputs
Hot Fill
Programmable Output 1
Programmable Output 2
Programmable Output 3
Softener
Detergent/Bleach
Table 20
keypad advances the control
63
Diagnostics Menu
Part No. 806526ENR2