-
sing the wing nuts, attach the receiver and transmitter of the photo system to the mounting brackets with
arrow pointing up . Note that the receiver and transmitter can be installed on the left side or right side of the door.
- Ad ust the position of the transmitter and receiver on the slot of the brackets. Secure the receiver and transmitter to
the mounting brackets as shown in figure .
-
air the two white wires and the two white grey wires together from transmitter and receiver.
- Connect these paired wires to the
as shown in igure .
NICE N-
T CE
M
ote
he M
photocell s stem has a ma imum range of
Installation
Note
hoto beams should be mounted as close to the door track inside the door to offer maximum
entrapment protection.
.
Select a location on the wall no more than
and right side of the door. oth brackets must be mounted at the same height for proper alignment.
.
rill holes in the wall and attach brackets to the wall using screws and nails provided as shown in ig. .
and
terminals on the logic board or interface module if applicable
ft
all installation
inches from the floor to install wall mounting brackets on the left
un isor protector optional