Advertisement
Secondary non-monitored safety device s
A standard -wire safety edge, non-monitored photo beams or any other non-monitored reversing devices with a
N. contact can be connected to terminals S and S as secondary non-monitored safety device.
Note More than one secondary non-monitored safety device can be connected to terminals S and S .
Important
o not remove the resistor that is factory installed across terminals S and S unless installing a -wire
electric edge.
-wire electric edge
A standard -wire electric edge can be connected across S and S terminals as a secondary safety device.
emove the factory-installed resistor across terminals S and S when using a -wire electric edge
C NNECTI N
E TE NA SIN
Connect an external single-button as shown in diagram. lease refer to Modes of operation for the functionality of
single-button.
M
ES
E ATI N
All operators leave the factory in the
operational mode is desired
Momentary on open and close
• pen utton Momentary activation opens the door.
EN
E
I E . Momentary contact from mid-stop opens the door to full open position. Constant activation when
door is opening, bypass mid-stop if enabled.
• Close button Momentary on close.
• Stop button Momentary activation stops the door.
• Single button device and single channel transmitter, -channel
SE
NCTI N
C MME CIA
everse.
• -button
C S radio transmitter Same as open, close, stop buttons.
• Safety evices
hen door is closing, momentary activation reverses the door.
• Timer to close N A
E-
TT N E ICE
mode setting please read all modes of peration and determine which
pen Stop Close everse.
NCTI N
pen Close
hen door is closing, momentary activation reverses the door
, ,
transmitter
Advertisement
