Advertisement
MI -ST
SET
Mid-stop feature can be used to open the door to a preset point prior to full open
position. Note
imits must be set prior to setting mid-stop position
To Activate mid-stop
.
Close the door to full close position.
.
Set the selector dial to Mid-stop position. Mid-stop
.
ress open push button. oor opens. nce the door reaches the desired mid-stop
position, stop the door by activating stop push button.
.
Set the selector dial to the desired mode of operation.
Note
hen door opens to the programmed mid-stop position, Mid-Stop
illuminate.
To e-activate the mid-stop position
.
Close the door to full close position.
.
Set the selector dial to Mid-stop position.
.
ress the stop button, Mid-stop is de-activated.
Modify mid-stop position
To modify the current mid-stop position, follow the same steps to activate mid-stop. The new mid-stop position will
override the old mid-stop position.
TIME T C
SE SET
Timer to close is enabled only in TS and T modes of operation. To ad ust the timer value turn
T clockwise to the desired value. The minimum value for timer to close is
the maximum value is
E AY N C
SE SET
can be used to delay the closing of the door in
de-activated in C ,
, E and T modes of operation. elay on close timer is
elay on close dial is set to
desired value. The minimum value for delay on close timer is
is
seconds. It is recommended to use this feature in apartment applications where E and
EEN traffic lights are used.
N TE In TS mode, the
counting. nless a delay on close is re uired this dial should be rotated to the
left in any other position but
N-
A
ECEI E
This logic board has a built-in
Nice single button, -button
INSTA
IN T E ANTENNA
irect Connection
Attach the antenna when supplied with the operator to the
or best reception, keep antenna wire straight and away from metal ob ects.
Indirect connection Mounting the antenna at a remote location
.
Connect coax extension cable optional to the
.
oute cable inside metal enclosure.
.
oute and secure cable away from moving parts.
.
Mount antenna holder not provided outside enclosure.
.
Attach antenna to extension wire.
.
osition antenna wire straight. or best reception, keep antenna away from
metal.
Note
o not route coax cable near any moving parts of the operator. If necessary, secure coax wire away from
any moving parts.
seconds.
only for use with optional apartment board
position. To ad ust this timer, rotate the dial clockwise to the
elay on close timer starts only once the Timer to close has finished
, activation of close button will delay to
AMMIN
M
radio receiver and can only be used with
EN C
SE ST
E starts blinking.
elay on close timer
and TS modes of operation. This timer is
second and the maximum value
T amount of time.
and -channel radio transmitters.
connector on the control box.
connector on the control box.
E will
seconds and
when the
position If
Advertisement
