Advertisement
• Timer to close Closes the door from mid-stop or full open. Momentary activation of stop button will de-activate the
timer.
hen door is closing, momentary activation of safety devices will reverse the door to mid-stop if enabled or full
open and de-activates the timer. Timer resumes its normal operation upon momentary activation of open push button or
once the close cycle is completed. If mid-stop is enabled and Timer from mid-stop only dip-switch is N, timer is
enabled only from mid-stop and disabled from full open. If mid-stop is enabled and Timer from mid-stop only dip-
switch is
, timer is enabled from full open and mid-stop.
TS Momentary on open and close, timer to close secure, ST
• pen utton Momentary activation opens the door.
Momentary contact from mid-stop opens the door to full open position. Momentary contact at full-open refreshes the
timer if enabled at full open. Momentary contact at full open position re-activates the timer if timer has been disabled
previously by stop button. Constant activation when door is opening, bypass mid-stop if enabled.
• Close button Momentary on close.
• Stop button If door is opening or closing, momentary activation stops the door.
Momentary activation while timer is counting at mid-stop or full open de-activates the timer.
• Single button device, single channel transmitter and -channel
SE
ENTIA
C MME CIA
• -button
C S radio transmitter Same as open, close, stop buttons.
• Safety evices
hen door is closing, momentary activation reverses the door.
Momentary activation refreshes the timer to close.
• Timer to close Closes the door from mid-stop or full open. Momentary activation of stop button will de-activate the
timer. Timer resumes its normal operation upon momentary activation of open push button or once the close cycle is
completed. If mid-stop is enabled and Timer from mid-stop only dip-switch is N, timer is enabled only from mid-
stop and disabled from full open. If mid-stop is enabled and Timer from mid-stop only dip-switch is
enabled from full open and mid-stop.
arning
hen replacing the logic board in a single-phase operator,
Make sure that umper
ailure to do this will damage the logic board.
AMMIN INST
N TE A
AM
SE ECT
S TIC T T E ESI E SETTIN AT ANY
E ATI N E CE T
M ST STA T
M T E
N-TIME SET
un-timer is the maximum amount of time the motor will run upon receiving an
open or close command. The factory default value for run-timer is
Note
imits must be set prior to setting run timer
Modify the run-timer from factory default
.
Close the door to full close position.
.
Set the selector dial to
E should blink.
.
ress open button.
to the time taken for the door to travel from full close position to full open position plus
seconds.
.
Set the selector dial to the desired mode of operation.
Modify the run-timer to factory default
.
Close the door to full close position.
.
Set the selector dial to
.
ress stop button. The run-timer is modified to the factory default value. Then set the selector dial to the
desired mode of operation.
NCTI N
pen Stop Close everse.
NCTI N
pen everse efresh timer.
is installed properly before operating the door.
CTI NS
NCTI NS CAN E INITIATE
T E MI ST
and
C
SE
SITI N.
un-timer position. The
ait until door reaches full open position. The run timer value is set
un-timer position.
TT N ISA
hen door is closing, momentary activation reverses the door.
, ,
radio transmitter
Y T
NIN T E
INT
IN
N TIME M
E,
seconds.
elay n Close Timer
ES TIME
AMMIN
, timer is
Advertisement
