Advertisement
SECTI N A PRO-
(
) compliant not a ailable in
C NNECTI N
E
I IN
se -
. Single phase Connect single phase power supply to terminals
terminal strip.
. Three-phase Connect three phase power supply to terminals
strip.
C NT
I IN
se
wiring. Note
o not run control wires and power wires in same conduit.
- Install control station within clear sight of door but away from all moving parts of door or hardware.
Install Entrapment warning sign next to control station. Connect -button open close stop push
button station to terminals , ,
button stations.
N TE After electrical connections are made, manually move door to mid-position and, using the control station press the
pen button for several seconds and then press the Stop button. If door did not move in correct direction
verify wiring control station. or -phase operators, if door still moves in wrong direction reverse any two of the
three incoming power supply leads to correct rotation.
IMIT S ITC A
- Ad ust imit switches as explained in the
PRO-H
tandard rela logic controls (not
E S
Y AN C NT
.
cm diameter holes for all power wiring.
.
cm diameter holes for all control
and . efer to electrical diagram for connection of two -
STMENT
imit switch ad ustment section further in this manual.
)
STATI N
line and N
on three-pole power
,
and
on three-pole power terminal
Advertisement
