Download Print this page

Nice Pro-H Instructions And Warnings For Installation And Use page 6

Automation for sectional and rolling doors

Advertisement

IM
TANT SA ETY INST
EA AN
-
Never allow children to operate or play with door controls. eep the remote control where provided away from children.
-
ersonnel should keep away from a door in motion and keep the moving door in sight until it is completely closed or
-
opened. N
NE S
Test the door s safety features at least once a month. After ad usting the limit of travel, retest the door operator s safety
-
features. ailure to ad ust the operator properly may cause severe in ury or death.
or products having a manual release, if possible, use the manual release only when the door is closed. se caution when
-
using this release when the door is open.
or death.
EE
S
-
operating or balanced door could cause severe in ury or death. ave trained door systems technician make repairs to
cables, spring assemblies, and other hardware.
ress the
EN device or use emergency disconnect mechanism if a person is trapped under the door.
-
SA E T ESE INST
-
this installation manual be located close to the door system.
IM
TANT INSTA ATI N INST
EA AN
Commercial door operators are never to be installed on a residential installation
-
Install only on a properly operating and balanced door. A door that is operating improperly could cause severe in ury. ave
-
ualified service personnel make repairs to cables, spring assemblies, and other hardware before installing the operator.
emove all pull ropes and remove, or make inoperative, all locks unless mechanically and or electrically interlocked to the
-
power unit that are connected to the door before installing the operator.
Install the door operator at least
-
o not connect the operator to the source of power until instructed to do so.
-
ocate the control station a within sight of the door, b at a minimum height of
-
it, and
c away from all moving parts of the door.
Install the Entrapment
-
or products having a manual release, instruct the end user on the operation of the manual release.
-
Install non-contact entrapment protection devices photocells and or contact entrapment protection devices
-
reversing edges . Note photocells should be installed at no more than
on the leading edge of the door.
CTI NS
T
E
CE T E IS
A
INST
CTI NS
C
SS T E AT
eak or broken springs may cause the door to fall rapidly, causing severe in ury
E
Y
E ATIN AN
CTI NS. The owner or users must understand the safety and operation of door system. Insure that
A
INSTA
ATI N INST
feet or more above the floor if the operator has exposed moving parts.
arning lacard next to the control station in a prominent location.
A NIN
IN
Y
A M
IN
.
A ANCE . See oor Manufacturer s wner s Manual. An improperly
CTI NS
CTI NS
EAT
feet so that small children cannot reach
from the floor. Edges should be installed

Advertisement

loading

This manual is also suitable for:

Pro-j