Advertisement
A A N-
T
- EAM
ote
he M
photocell s stem has a ma imum range of
.
Select a location on the wall no more than
and right side of the door. oth brackets must be mounted at the same height for proper alignment.
.
rill holes in the wall and attach brackets to the wall using screws provided as shown in ig. .
ig.
.
lug sensors into flexible adapters as shown in ig. . lease note that the
receiver
x must be installed into the receiver adapter and the transmitter Tx must be installed into the transmitter
adapter
ig.
.
ig.
.
air the two black and the two black with white tracer wires together from transmitter and receiver. Connect these
paired wires to the
. se minimum
.
Turn the power on to the operator. Align transmitter and receiver by ad usting angle and height of the fixture
and
.
ig. A
.
tili e E s on photocells for alignment and trouble shooting. Make sure to tighten screws and wing nuts
after photocells are aligned.
ed E
•
ed E
•
ed E
•
ed E
•
ed E
•
or interchange position of transmitter and receiver to reduce sunlight affecting receiver.
To test the photo system
beam. The door should stop and reverse.
T CE
M
inches from the floor to install wall mounting brackets on the left
and
terminals on the logic board or interface module if applicable as shown in ig
gauge wires and secure the wires to wall or ceiling.
Angle Ad ustment
N , reen E
N Normal operation
, reen E
No power. erify wiring
linking twice , reen E
linking twice , reen E
linking three times , reen E
pen the door to full open position. Close the door.
ft
un isor protector optional
ig.
ig.
N
ad Alignment, or bstructed eam, or x defective
Check power and wiring to x, or x defective
N
x receiving sunlight or interference . Install visor
brackets are not identical. The
eight ad ustment
oosen wing nut first
hen door is closing, obstruct the
ig. A
Advertisement
