Advertisement
SECTI N
PRO- (M) PRO-H(M) Rela logic controls with nterface
Module (
perator electrical connections and start-up instructions
NOTE: THIS OPERATOR COMES WITH AN INTERFACE MOUDLE INTEGRATED INTO THE
CONTROL CIRCUIT. THE PURPOSE OF THE INTERFACE MODULE IS TO ALLOW FOR FAILSAFE
MONITORING OF A NICE COMPATIBLE SAFETY DEVICE AS PER UL 325 (2010) REQUIREMENTS
Important
Connect ower supply
ingle phase Connect single phase power supply to terminals
terminals strip. -phase Connect -phase power supply to terminals
terminal strip.
Connect ush-button station for installation purposes single phase or -phase
Connect open close stop push button station to terminals T
erify motor direction
After the electrical power connections are made and push button station is connected, manually move the door to mid-
position. ress Close button for several seconds and then press stop button. If door did not move in correct direction
or if limit cams not moving in correct direction towards the close limit switch see below
(
) compliant)
ollow these steps carefully and in the order shown
and N
on the -pole power
,
and
on the -pole power
stop , T
common , T
open and T
temporary C on close .
Advertisement
