Download Print this page

Nice Pro-H Instructions And Warnings For Installation And Use page 25

Automation for sectional and rolling doors

Advertisement

SECTI N E
or perators with Interface Modules or ogic boards
INSTA ATI N
NICE N-
Installation Safety recautions
A NIN
Nice M
with Nice logic board operators or relay logic operators e uipped with the Nice failsafe interface module.
this device on other than recommended operators can lead to severe or fatal in ury. ollow these instructions
carefully.
IM
TANT
or momentar
must be installed as part of the operator s stem
photobeam system is not installed or not operating correctly , the operator will only operate in fault mode
constant pressure to close .
EA and
all installation instructions.
.
efore installing the photo beam, read the door or gate operator s instruction manual fully, so you are aware of
all of the unit s functions and features.
.
ear protective gloves and eye protection when using tools.
.
efore installing photo beam, disconnect all power to door operator to prevent unintended operation and have the
door full open or close.
.
o not reconnect power to the door or gate operator until instructed to do so.
.
nly install photobeams on a properly functioning door or gate operator.
.
Installation and wiring must comply with local building and electrical codes. This device is not intended and must
not be installed in an explosive environment.
A NIN
eep fingers and other body parts away from all moving parts of the door and gate operator system while
the system is being operated.
A NIN
To prevent unintended operation, disconnect power to the door or gate operator prior to installing
the photobeam system.
NICE N-
T CE
M
ote
he M
photocell s stem has a ma imum range of
Installation
Note
hoto beams should be mounted as close to the door track inside the door to offer maximum
entrapment protection.
.
Select a location on the wall no more than
and right side of the door. oth brackets must be mounted at the same height for proper alignment.
.
rill holes in the wall and attach brackets to the wall using screws and nails provided as shown in ig. .
N-
T CE
NEMA-
and
A A M
acti ation on close the Nice photobeams (or a Nice
inches from the floor to install wall mounting brackets on the left
S
NEMA
If a Nice
-wire monitored edge or the Nice infrared
ft
un isor protector optional
all installation
infrared photo systems are for use only
-wire monitored edge)
se of

Advertisement

loading

This manual is also suitable for:

Pro-j