Advertisement
AMMIN T E N-
arning
uring programming, door operator will activate. eep people and ob ects away from door.
.
Connect power to door operator.
.
ress and release the learn button once. The receiver s E will turn on.
.
To program a single button transmitter, press the button on the
transmitter. The receiver s E will blink twice indicating a
successful programming.
.
ress the button on the transmitter once more to confirm operation
of the door operator.
.
To program a -channel
E will blink twice indicating a successful programming. ress the same button on the transmitter to confirm
operation of the door operator. This button is now associated with that particular receiver. You can repeat the
programming process for the other two buttons to control two other receivers.
.
To program a -button
twice indicating a successful programming. ress the
the door operator.
the operator respectively.
.
Test range of transmitter. epositioning antenna may provide greater range.
.
epeat transmitter-programming steps for additional transmitters.
E ATI N
.
ress and release the button on Nice transmitter.
.
eceiver E will light momentarily and door will cycle.
T E ASE A
EA NE T ANSMITTE S
.
ress and hold down the EA N button.
.
After
seconds, the E will blink for
.
elease the EA N button during the time E is blinking.
.
After you released the button, the E will blink
receiver s memory.
Note
ma imum of
factor
E
ACIN
EM TE C NT
The batteries lithium,
removing the screws on the back of the transmitter. Match the positive and negative terminals of the battery to the
positive and negative terminals of the transmitter.
Note The receiver and transmitter comply with part
is sub ect to the following two conditions
accept any interference received, including interference that may cause undesired operation.
Note If an external radio-receiver Nice or other is used instead of the built-in radio receiver, it is highly
recommended to disconnect the co-axial cable from the logic board.
Note
hen using any external receiver, the Nice on-board receiver should not be used.
A
A I
ECEI E
, ,
transmitter, press any of the
C S transmitter, press
EN, C
SE and ST
transmitters can be programmed for the same recei er f more than
ATTE IES
should produce power for up to
this device may not cause harmful interference, and
buttons on the transmitter. The receiver s
EN button on the transmitter. The receiver s E will blink
EN button on the transmitter to confirm operation of
buttons on the transmitter can be used to open, close and stop
seconds.
times indicating all transmitters are erased from the
years. To replace the battery, open the transmitter by
of the CC rules with SS-
are re uired consult
of industry Canada. peration
this device must
Advertisement
