8.7.4
Tool analog input
The tool analog input is a non-differential input, with voltage (0-10V). The electrical
specifications are shown below.
Parameter
Input voltage
Input resistance
Resolution
Two examples of how to use the analog input are illustrated in the following section.
Using the tool analog input, non-differential
This example illustratesan analog sensor connection with a non-differential output.
Using the tool analog input, differential
This example illustrates an analog sensor connection with a differential output. Work in the
same way as the non-differential sensor after connecting a negative output end to the GND (0V).
8.7.5 Tool analog output
The tool analog output is a non-differential output, with voltage (0-10V). The electrical
Min
Type
-0.5
-
-
-
10
-
Page 54 of 130
Doc No.:T202001005
Max
Unit
24
V
>100
MΩ
Bit
-
www.elibot.cn