Otto Bock Manu Sensa 50P13 Instructions For Use Manual page 11

► Always apply the product according to the information in the instruc­
tions.
The plastic splint is anatomically pre-shaped. The splint can be heated and
then individually shaped.
1) Heat the splint using a hot air gun.
2) Shape the splint.
3) Allow the splint to harden.
4) Insert the splint into the pocket on the inside of the support (see fig. 1).
4.3 Application
CAUTION
Incorrect or excessively tight application
Skin irritation due to overheating, local pressure points due to tight appli­
cation to the body
► Ensure that the product is applied properly and fits correctly.
► When in doubt, do not continue to use the product if skin irritation
occurs.
NOTICE
Use of a worn or damaged product
Limited effectiveness
► Before each use, check the product for functional reliability and for
possible wear or damage.
► Do not continue using a product that is no longer functional, or that is
worn or damaged.
1) Pull the support over the hand, guiding the thumb through the smaller
opening (see fig. 2).
2) Optional: The supplied strap can be used for additional stabilization.
Pull the elastic strap around the wrist and fasten the hook-and-loop clo­
sure (see fig. 4).
3) Check the proper fit of the support.
5 Cleaning
NOTICE
Use of improper cleaning agents
Damage to the product due to use of improper cleaning agents
► Only clean the product with the approved cleaning agents.
11