Flexible Ducting System - Immergas VICTRIX PRO 1 I Series Technical Sheet

VICTRIX PRO 1 I
42 Ø 80 FLEXIBLE DUCTING SYSTEM
The Immergas Ø 80 mm system for flexible ducting of existing
chimneys is made up from a series of components, identified
as individual kits, which can be assembled depending on the
specific installation requirements. This system is supplied in a
configuration that envisions an ascending 87° input bend, then
continuing vertically with the Ø 80 flexible hose and the exhaust
terminal. The ducted tube is inspected at the mouth of the boiler,
via the relevant hatch.
The kit is made up from a 12 m flexible hose. If the hose is too
short it can be joined to other pieces via the relevant adapters.
A centring spacer must however be inserted every now and
again, which via extendible fins, allows the pipe to stay in the
centre of the flue.
The maximum length for this ducting system is:
VICTRIX PRO 35 1 I = 24 m
VICTRIX PRO 55 1 I = 30 m
VICTRIX PRO 80 1 I = 28 m
VICTRIX PRO 100 1 I = 14 m
VICTRIX PRO 120 1 I = 8.5 m
This length is obtained by considering:
- 1 Ø 80 mm 90° bend for connection to the boiler (exhaust);
- 1 m of Ø 80 pipe for exhaust;
- two direction changes in the vertical section;
- the supporting Ø 80 mm bend;
- the vertical terminal kit for Ø 80/125 ducting.
It is important to highlight that:
- in all cases it is a system to which a unique appliance can be
coupled;
- the system can only be coupled with condensing appliances.
52