Hydraulic Kit Measurements And Fittings (Optional) With Single Victrix Pro 35 1 I-55 1 I Boiler - Immergas VICTRIX PRO 1 I Series Technical Sheet

8 HYDRAULIC KIT MEASUREMENTS AND FITTINGS (OPTIONAL)
WITH SINGLE VICTRIX PRO 35 1 I-55 1 I BOILER
N.B.: In case of installation outside, the safety devices kit must
be protected using the IPX4D protection box kit for individual
boiler safety devices, code 3.024028.
Immergas S.p.a. declines all liability whenever the installer does
not use approved devices and Immergas original kits or uses
them improperly.
The sensitive elements of the safety devices must be set up as
described in the installation instructions, in compliance with
the provisions cascade forth in the "R" collection.
For design purposes, by installing the Immergas safety device
kit, the following are already included: Manometer-holder cock,
12
3/4"
1"
1"
2" 1/2
R
M
manometer, thermometer, manual reset thermostat, manual
reset maximum pressure switch, and manual reset minimum
pressure switch (the boiler is already equipped as per standard
with 4-bar safety valve and standard draining funnel).
There is a fitting for an expansion vessel on the flow and return
stub pipes.
1/2"
3/4"
1" 1/2