Kit Sizes And Connections (Optional) With Victrix Pro 80 1 I Boilers In Cascade Configuration (Up To A Maximum Of Five Appliances) - Immergas VICTRIX PRO 1 I Series Technical Sheet

16 KIT SIZES AND CONNECTIONS (OPTIONAL) WITH VICTRIX PRO 80 1 I BOILERS
IN CASCADE CONFIGURATION (UP TO A MAXIMUM OF FIVE APPLIANCES)
Reference 2 boilers
X 2133 mm
Y 2316 mm
Z 62 mm
Ø 200 mm
N.B.: In case of installation outside, the safety devices kit must be
protected using the IPX4D protection box kit for safety devices for
boilers in cascade configuration, code 3.024038.
Immergas declines all liability whenever the installer does not use
original Immergas devices and kits, or uses them improperly.
The sensitive elements of the safety devices must be set up as
described in the installation instructions, in compliance with the
provisions cascade forth in the ''R'' collection.
For design purposes, by installing the Immergas safety kit, the
following devices are included: Manometer-holder cock, ma-
nometer, thermometer, manual reset thermostat, manual reset
maximum pressure switch, and manual reset minimum pressure
switch (the boiler is already equipped as per standard with 4-bar
safety valve and standard draining funnel).
20
VICTRIX PRO 80 1 I -100 1 I - 120 1 I
3 boilers 4 boilers
2933 mm 3733 mm
2358 mm 2400 mm
104 mm 146 mm
200 mm 200 mm
5 boilers
4533 mm
2442 mm
188 mm
200 mm
There is a fitting for an expansion vessel on the flow and return
stub pipes.
The modular boilers, i.e. installed in cascade (battery) with an Im-
mergas original hydraulic manifold kit, must be considered a unique
appliance, which assumes the serial number (factory number) of
the boiler nearest to the safety devices. It is therefore possible to
set up up to 5 (five) modules side-by-side, with a single safety kit.
The hydraulic manifolds (optional) are equipped with non-return
valve positioned on the flow pipe and with system interception cocks
positioned on the flow and return pipes of every boiler (2-way on
return and 3-way on flow).