Update Instrument Software - Keysight Technologies N9010B EXA Installation Note

Hide thumbs Also See for N9010B EXA:

Installation Procedure

6. Refer to the data in

N90x0B-CRP installed, verify that it also has a Front End Controller with Hw Id of 75. If the

Front End Controller has a Hw Id of 75, you do not need this upgrade kit, since the necessary

hardware is already present. Refer instead to upgrade products N90x0BU-CR3 and

N90x0BU-CRP.

7. Refer to the data in

installed, verify that it also has a Front End Controller with Hw Id of 75. If the Front End

Controller has a Hw ID of 75, you do not need this upgrade kit, since the necessary hardware is

already present. Refer instead to upgrade products N9010BU-CR3 and N9010BU-CRP.

8. Refer to the data in

N90x0B-CRP installed, and the Front End Controller does not have a Hw Id of 75, proceed to

the next step. Although the licenses for N90x0B-CR3 and/or N90x0B-CRP are installed, the

necessary hardware has not been installed.

Update Instrument Software

Go to the following website and determine whether or not the analyzer has the latest instrument

software already installed:

http://www.keysight.com/find/xseries_software

If the analyzer does not have the latest instrument software already installed, download and install

the latest version.

step 3

and

step 4

above. If the analyzer has N90x0B-CR3 and/or

step 3

and

step 4

above. If the analyzer has N9010B-532 or N9010B-544

step 3

and

step 4

above. If the analyzer has N90x0B-CR3 and/or

Installation Note N9010-90066

Table of Contents

N9020b mxa