Keysight Technologies N9010B EXA Installation Note page 24

Installation Procedure
7. Refer to Figure 15. Reconnect W12 to A3J14. Reconnect W13 to A3J15.
Figure 15 Reconnect W12 and W13
8. Locate W39 in the Opt HL3 Cable Kit. This cable will have part number 8121-2028 and will be
labeled "1100" one end and no label on the other. Connect the end labeled "1100" to
A15J1100 on the A15 EFEC Assembly. Route the cable along the left side of the chassis above
the fans toward the rear panel. The other end of the connector will be secured to the rear panel
later.
24 Installation Note N9010-90066