Keysight Technologies N9010B EXA Installation Note page 13

Portable Instrument (Option PRC)
1. Disconnect the instrument from ac power.
2. Refer to Figure 4. Using the T-20 driver, remove the four screws (1), two on each side, to
detach the Bail Handle Assembly (2) from the front frame.
Figure 4 Bail Handle and Front Bumpers Removal (Option PRC)
3. Using the T-20 driver, remove the four screws (6) (two on each side) that attach the four strap
handle plugs (5) from both sides of the instrument.
Installation Note N9010-90066
Make sure any adapters on the front panel are removed.
Installation Procedure
13