Installing A Tool - Roland CAMM SCRIBE CS-20 User Manual

Using the Optional CP-A3 Cutting-use
Protective Pad...
Cut to fit the size
of the table

Installing a Tool

The steps for installing a tool are shown below. Follow these steps to install the appropriate tool for the task.
For Engraving (Character Cutter)
When installing a cutter for engraving, make sure the blade tip protrudes beyond the surface of the material by an amount equal
to the depth of engraving to be performed.
Move the tool carriage to a position over the material surface, then install the cutter.
Install the depth regulator nose as shown in the
1
figure.
Screw
part
The spanner included with
the unit is 3 mm (1/8") thick,
and can be used as to check
the width of the space.
Provisionally tighten the character cutter in the
3
engraving-tool holder, and install the engraving-tool
holder on the tool carriage.
2. Rotate in the direction
of the arrow.
Material
CP-A3
Peel off the
backing paper
Adjust the screw so to make
this space 3 mm (1/8").
3 mm (1/8")
Engraving-
tool holder
Hexagonal
screw driver
1. Turn in the direction
of the arrow to
tighten provisionally.
• The peel-off sheets are used
to protect the CP-A3 after
use.
Do not throw them away.
• One CP-A3 can be used
about 100 times. Replace it
once it loses its grip (sticki-
ness).
********** CUTTER
* Use SELECT key to choose "ENGRAVER" as the mode.
Loosen the tool mounting screw and insert the depth
2
regulator nose in the tool carriage.
3. Retighten the tool
mounting screw to
secure the nose in
place.
Press the SET SURFACE key to lower the tool,
4
then loosen the screw for the engraving-tool holder.
********** **********
1. Line up the
protrusion with
the groove on
the front, and fit
it in the groove.
2. Rotate in the
direction of
the arrow.
Hexagonal
screw driver
7