Attaching A Vacuum Cleaner - Roland CAMM SCRIBE CS-20 User Manual

Spindle Speed
Adjust the spindle speed to match the material being engraved.
Depending on the material, a spindle speed that is too fast may
cause the material to melt.
Turn the r.p.m knob on the control panel to change the spindle speed.
Cutting and Plotting Speed
Turn the SPEED knob on the control panel to
change the cutting and plotting speed (tool-move-
ment speed.)
The tool-lowering speed also changes accordingly.
When the values set within the application software or the driver are sent after adjusting the cutting and plotting speed on
the CAMM SCRIBE, the software and driver values are changed.
Conversely, you can also change the cutting and plotting speed by rotating the knobs on the CAMM SCRIBE after starting
a cutting operation using the software and driver values.

Attaching a Vacuum Cleaner

The dust collector hose and duct included with the CAMM SCRIBE can be attached to an ordinary household vacuum cleaner to
remove cuttings during engraving.
Always allow a minimum gap of 30 cm (12") on the side where the vacuum hose exits. The vacuum hose must have sufficient
space in which to move. When the vacuum hose cannot move smoothly, it can cause malfunctions or errors in operation.
Vacuum duct
32 mm (1-5/16")
30 cm (12") or more
When the fitting diameters do not match or when the vacuum duct cannot be inserted into the suction opening of the
vacuum cleaner, use strong commercial tape (cloth or electrical) to join the fittings.
Vacuum
hose
Slower
speed
Engraving
Engraving using
a fine engraving
blade (ZEC-
H2010)
Slower
speed
Faster
speed
Faster
speed
Cutting/plotting/scoring
13