Roland CAMM SCRIBE CS-20 User Manual page 18

Loosen the tool mounting screw and insert the tool
3
adapter into the tool carriage.
Retighten the tool mounting
screw to secure in place.
For the Scoring (Diamond scraper)
When performing scoring, be sure to purchase the diamond scraper (optionally available).
Loosen the tool mounting screw and insert the
1
special adapter into the tool carriage.
Retighten the tool mounting
screw to secure in place.
Loosen the screw for the engraving-tool holder and
3
lower the blade of the diamond scraper until it
protrudes about 1 mm (1/16") from the tip of the
adapter.
10
* If the depth regulator nose is
installed, it should be removed.
* If the depth regulator nose is
installed, it should be removed.
Hexagonal
screw driver
1 mm (1/16")
* If the sheet is to be applied to a hard material such as glass
or an acrylic panel, it is possible to eliminate the transfer
step and enable smaller characters to be cut by affixing the
sheet to the material first, before cutting.
< Example >
1. Prepare the sheet to be cut.
2. Prepare the rigid material (acrylic panel, glass panel,
etc.).
3. Peel off the backing paper from the sheet and affix the
sheet to the rigid material.
4. Use double-sided tape or the like to secure the rigid
material with the affixed sheet to the table.
5. Perform cutting.
6. Peel off the unneeded portions.
* Use SELECT key to choose "PEN (SCORE)" as the mode.
Provisionally tighten the diamond scraper in the
2
engraving-tool holder, and insert it into the tool
carriage.
2. Rotate in the direction
of the arrow.
Tighten the screw securely to secure the tool in
4
place.
Engraving-
tool holder
Hexagonal
screw driver
1. Turn in the
direction of the
arrow to tighten
provisionally.
Hexagonal
screw driver