Roland CAMM SCRIBE CS-20 User Manual page 16

Gently lower the cutter until the tip of the blade
5
touches the surface of the material.
Press the SET SURFACE key to raise the cutter.
7
Use the spanner to turn the depth regulator nose in the direction of the arrow to extend the blade depth to the desired
engraving depth.
When engraving an acrylic panel, the depth that can be engraved at one time is about 0.25 mm (0.01").
To engrave to engrave to a greater depth, repeat the same engraving several times, increasing the amount
of blade extension with each pass until the desired engraving depth is reached.
Example: Engraving to a depth of 1 mm (0.04")
How to Remove the Cutter for Engraving
Rotate in the direction of
the arrow and remove.
8
Material surface
Spanner
[Number of engraving passes] : 4
[Amount of blade extension]
1st pass: 0.25 mm (0.01") -> 2nd pass: 0.5 mm (0.02") ->
3rd pass: 0.75 mm (0.03") -> 4th pass: 1 mm (0.04")
Engraving-
tool holder
Use the spanner to
tighten and secure in place.
Tighten the screw securely to secure the blade in
6
place.
Turning the nose by an amount
equal to the length of one side
causes the tool to be extended
by 0.125 mm (0.005").
(One turn corresponds to
0.75 mm (0.03") )
How to Remove
the Depth Regulator Nose
Loosen
Hexagonal
screw driver
Rotate in the direction of
the arrow, line up with the
groove, and remove.