Roland CAMM SCRIBE CS-20 User Manual page 17

For Pen Plotting
Insert the pen into the tool adapter, insert the spring
1
that comes with the tool adapter, then attach the cap.
* The pen uses indelible ink and
can rapidly dry out. Be sure to
cap the pen when not in use.
Pen
Tool adapter
For Cutting
Do not drop or damage the blade holder. Damage to the blade holder may impede its movement within the tool adapter.
Insert the blade into the blade holder until it snaps
1
into place with an audible click.
Insert the blade holder into the tool adapter. Then, depending on the thickness of the material to be cut, insert the
2
spacer or spring included with the tool adapted, or attach the cap without inserting either the spacer or the spring.
Blade holder
Tool adapter
* Select in order of "Spacer" , "Spring" and "None" when thinner the material becomes.
* Use SELECT key to choose "PEN (SCORE)" as the mode.
Cap
Spring
* The spacer
is not used.
* Use SELECT key to choose "CUTTER" as the mode.
Cap
Spacer
Spring
None
Loosen the tool mounting screw and insert the tool
2
adapter into the tool carriage.
* If the depth regulator nose is
installed, it should be removed.
Retighten the tool mounting
screw to secure in place.
The tool can be removed
by pressing the push-pin.
Push-pin
Cutting force Fluorescent and
1 kgf reflective sheets, etc.
Cutting force Sheets for indoor/
80 gf outdoor use, etc.
Cutting force Sheets for outdoor
35 gf use, etc.
Remove the cap.
For fine adjustment of
the blade tip, turn the
lower part of the blade
holder.
9