Table of Contents
Advertisement
4.2.3. Adjustment of indent height "H"
Choose on spindle shaft (A) the desired height. The lowest value of 6mm. is
obtained by positioning the mill cutter on the first notch to the left of the scale,
identified with minus (-) sign, and lock the setscrew (B). Each notch of the scale
increase the indent height of 1mm. (Every time the mill cutter is shifted of one
indexing clockwise (+) sign, the spindle assembly must be raised of 1mm. actin
the adjustment shaft (C) to maintain the same indent accuracy. Lock in position with
screw (D).
D
4.2.4 Adjustment of male indent t
Position the support of mobile chaser (A) to the limit stop backwards by operating
the start cycle push button. Remove cover, unlock screw (B), and adjust regulator (C)
with special tool and then lock.
4. OPERATION
C
hickness "S"
B
C
g on
4-7
will
Advertisement
Table of Contents
