Table of Contents
Advertisement
3.2 MOUNTING THE WHEEL ANGLE SENSOR
Figure 5 and Figure 6 show a detailed view of the
structure of a wheel angle sensor assembly. Table 5
also lists the components shown in Figure 5.
TABLE 5 WHEEL ANGLE SENSOR COMPONENTS.
Symbol Description
1
Sensor housing
2
Sensor disc
3
Mounting bracket 3mm
4
Mounting strip 20x 3mm
5
2 x M5 x 16mm (countersunk
head)
6
2 x M5 x 30mm
3.2.1
MOUNTING OF WHEEL ANGLE SENSOR
HOSING TO STANDARD FRONT AXLE
1. If the front wheels are straight, the screws of
the sensor housing and sensor disc should be
aligned with the front axle. In case of a 12V
wheel angle sensor, it is also important that the
sensor disc is rotated in such a way that the
triangles in the disc and the sensor housing
(Figure 7) are properly aligned. Only then will
the wheel angle sensor produce a voltage
reading.
2. The sensor housing and sensor disc must be
aligned EXACTLY on the pivot point of the stub
axle. The centre-to-centre distance of the
mounting holes is 28 mm.
Please note!:
With a 12V wheel angle sensor, the triangles on
the sensor housing and sensor disc must be
pointing in the same direction!
PAGINA 17/48 | Installation manual | 016-8000-098EN | Rev. A
MOUNTING WHEEL ANGLE SENSOR | SBGUIDANCE | SMARTRAX MD
FIGURE 5 SCHEMATIC OVERVIEW OF WHEEL
ANGLE SENSOR WITH MOUNTING BRACKET
AND STRIP.
FIGURE 6 SCHEMATIC DRAWING OF WHEEL ANGLE
SENSOR WHEN MOUNTED.
Advertisement
Table of Contents
