Mounting Wheel Angle Sensor; Mounting Spy-Cable - Raven SBGUIDANCE SMARTRAX MD Installation Manual

MOUNTING WHEEL ANGLE SENSOR | SBGUIDANCE | SMARTRAX MD

3 MOUNTING WHEEL ANGLE SENSOR

For a correct operation of the SBGuidance Smartrax
MD system a wheel angle sensor is necessary. In
various types of tractors a factory fitted wheel angle
sensor is already mounted in the front axle. For
different tractor types a 'spy cable' is available at
Raven Europe to use the factory fitted wheel angle
sensor for the Raven system. When a spy cable is used
it is not necessary to install a wheel angle sensor. Ask
Raven Europe for more information about the
availability for a specific tractor brand or type.

3.1 MOUNTING SPY-CABLE

Take the following steps to mount a wheel angle
sensor spy-cable:
1. Follow the cable from the wheel angle sensor
on the front axle pf the tractor to the first
connection in this cable.
2. Disconnect the connectors.
3. Connect the spy-cable in between the
connectors.
4. Connect the wheel angle sensor 5M cable to
the M12 connector of the spy-cable.
5. Mount the spy-cable in a clean and dry
position (Figure 4).
Raven Industries Inc.
FIGURE 4 SPY CABLE MOUNTED ON A CNH
TRACTOR.
PAGINA 16/48 | Installation manual | 016-8000-098EN | Rev. A