ABB ControlIT 53MC5000 Instruction Manual page 282

LOOP 1 AND LOOP 2
MISCELLANEOUS DATAPOINTS (SHOWN IN
RECTANGLES ON THE DISPLAY)
UNIT TAGNAME (A008) [ABB MC5000]
CONTROL TAGNAME (A000, A002) [CON-0,
CON-1]
ENGINEERING UNITS (A001, A003) [PERCENT]
(FOR TREND DISPLAYS)
LOOP 1 AND LOOP 2
ALARMS RELATED DATAPOINTS
CONTROL ALARM MODE (B335, B340)
0 - HIGH/LOW
1 - NONE
2 - HIGH/NONE
3 - NONE/LOW
4 - HIGH/HI-HI
5 - LOW/LO-LO
6 - HI SP DEVIATION/LO SP
DEVIATION
ALARM LIMIT 1 (C103, C139)
ALARM LIMIT 2 (C104, C140)
ALARM DEAD BAND (C105, C141)
Figure 15-2. CS41 Four Loop Controller Datapoints (Sheet 3 of 4)
Section 15. CS41 - Four Loop Controller
AO0 - CONTROL OUTPUT LOOP 1 RELATED DATAPOINTS
AO0 0-20 mA OUTPUT (L472)
MANUAL FALLBACK DISABLE (L120)
HARD MANUAL LIMIT (L122)
OUTPUT HIGH LIMIT (C109)
OUTPUT LOW LIMIT (C110)
OUTPUT SLEW RATE (C118)
CON0 CONTROL RELATED DATAPOINTS (SEE SECTION 16,
TUNING, OR SECTION 17, EASY-TUNE, TO TUNE PID DATA-
POINTS)
PROPORTIONAL BAND (C106) (P)
RESET TIME (C107) (I)
RATE TIME (C108) (D)
MANUAL RESET (C111)
REVERSE SWITCH (L106)
AUTO ENABLE (L114)
CONTROLLER SPAN (C115) [100] (FOR TREND DISPLAYS)
CONTROLLER LOWER RANGE (C116) [0]
(FOR TREND DISPLAYS)
AO0 - CONTROL OUTPUT LOOP 1
CCO0 - PROCESS ALARMS LOOP 1
(CONTACT OUTPUT INVERT [L288])
CCO1 - PROCESS ALARMS LOOP 2
(CONTACT OUTPUT INVERT [L289])
AO1 - CONTROL OUTPUT LOOP 2
AO1 - CONTROL OUTPUT LOOP 2 RELATED DATAPOINTS
AO1 0-20 mA OUTPUT (L473)
MANUAL FALLBACK DISABLE (L144)
HARD MANUAL LIMIT (L146)
OUTPUT HIGH LIMIT (C145)
OUTPUT LOW LIMIT (C146)
OUTPUT SLEW RATE (C154)
CON1 CONTROL RELATED DATAPOINTS (SEE SECTION 16, TUN-
ING, OR SECTION 17, EASY-TUNE, TO TUNE PID DATAPOINTS)
PROPORTIONAL BAND (C142) (P)
RESET TIME (C143) (I)
RATE TIME (C144) (D)
MANUAL RESET (C147)
REVERSE SWITCH (L130)
AUTO ENABLE (L138)
CONTROLLER SPAN (C151) [100] (FOR TREND DISPLAYS)
CONTROLLER LOWER RANGE (C152) [0]
(FOR TREND DISPLAYS)
MULTIPLE DATAPOINTS: (LOOPS 1 AND 2)
15-7