Table of Contents
Advertisement
General safety information
max.
30 kg
1 m
6 | EN
1 5
Applicable documents
– General construction approval of Deutsches Institut für Bautechnik
(DIBt) in Berlin, Germany, Approval number Z-19.30-2229
– DIN VDE 0298 Part 4 (June 2013): "Application of cables and cords in
power installations"
– Safety data sheet "Ablation coating ASX"
1 6
Recommended documents
– Fire protection guide for electrical installations (published by: OBO
Bettermann).
– LFS system instructions (published by: OBO Bettermann).
2
General safety information
When handling the product, please observe the following safety informa-
tion, in order to avoid damage to people and property:
The maximum approved total load is 30 kg per running duct metre. It may
not be exceeded, as otherwise the support and function capability is no
longer guaranteed.
The fastening substrate must have a sufficient carrying capacity and be
suitable for the appropriate, fire protection-tested fastening material. For
this reason, dry/lightweight construction walls are only partially suitable,
and suspended ceilings unsuitable.
The fire protection duct is not designed to support walls in wall penetra-
tions. Ensure that the wall penetrations can support themselves.
Cable routing systems can fail when they are used as support areas. In-
jury will result from such a fall. Do not subject cable routing systems to
your body weight.
If components of the fire protection duct system are touched with bare
hands, then serious cuts could result due to sharp edges. Always wear
suitable protective gloves when handling the system.
If there is a fire in the interior of the duct, the burned cable insulation will
create corrosive gases, which have an irritant and corrosive effect. Before
opening and disposing of duct sections which have been subjected to a
fire, wear breathing protection and protective clothing.
OBO Bettermann
Advertisement
Table of Contents
