Table of Contents
Advertisement
Mounting on a support system
66 | EN
6 3 9
Mounting an end piece
The end piece closes off the end of a duct. The support profile suspend-
ed from threaded rods (BSKM-AD 0407, BSKM-AD 0711 or BSKM-AD
1025) is used as a support element for the duct section. Together with
the screwed-on end piece (BSKM-VK 0407, BSKM-VK 0711 or BSKM-VK
1025), it ensures the necessary tightness.
For information on closing off a duct with onward cabling, see "10.2 Cre-
ating wall end covers" on page 75.
See Fig. 64:
1
Stick the self-adhesive sealing strip to the lock plate.
2
Fasten the threaded rods to the ceiling and fasten the support profile
to the threaded rods with washers and nuts at the desired height.
3
Shorten the ducts as necessary and then re-drill the duct fastening
holes (see Fig. 12 on page 18). If necessary, use locking brackets
for the duct lid (see "4.4 Inserting locking brackets" on page 19).
Remove the duct lid and fix the duct with two self-tapping screws
each (contained in the scope of delivery of the support profile) on the
support profile.
4
Insert cables.
5
For duct BSKM 1025: insert lid support (see "4.5 Using lid support"
on page 20).
6
Attach the duct lid firmly.
7
Attach the end piece and screw on with the supplied nuts.
8
Using the connecting screw (contained in the scope of delivery of the
end piece), create the equipotential bonding (see "8.1 Create equipo-
tential bonding" on page 72).
OBO Bettermann
Advertisement
Table of Contents
