Table of Contents
Advertisement
03/10 Rev. 5.04-04
1. Switch the printer off.
2. Remove the rear hood.
3. Connect a multimeter to the print head voltage.
4. Switch the printer on while pressing the Feed + Prog buttons.
5. Select parameter
6. Change the head voltage by pressing the Cut or Feed key until you
7. Press the online key to store the value into the power supply.
8. Select parameter "Headvo. adj. 28 V".
9. Change the head voltage by pressing the Cut or Feed key until you
10. Press the online key to store the value into the power supply.
11. Switch the printer off.
12. Connect the voltage cable to the power pack.
13. Close the rear hood.
SERVICE MANUAL
64-xx – 64-xx Dispenser
Adjusting the printhead voltage
This adjustment can not be applied to the currently (since 01/2008) built-in
power supplies. It is only applicable to NT400 power supplies, which were
built-in in 64-04/-05 and -06 printers up to 01/2008.
Proper adjustment of the printhead voltage to the same limit values is
required to make printouts comparable.
The printhead voltage can be adjusted to a lower limit of 20 V and an upper
limit of 28 V, using the parameters
SERVICE FUNCTIONS > Headvo. adj. 28
Adjust the printhead voltage as follows:
For a description read chapter
See chapter
Special key combinations
SERVICE FUNCTIONS > Headvo. adj. 20
measure 20 V +/- 0.1 V .
measure 28 V +/- 0.1 V .
SERVICE FUNCTIONS > Headvo. adj. 20 V
V.
Rear hood
on page 7 for details.
on page 4.
V.
48
Service Mechanics
or
Advertisement
Table of Contents
