Replacing The Printhead - Avery Dennison 64 Series Service Manual

03/10 Rev. 5.04-04

Replacing the printhead

Disassembling
1. Switch off the printer an unplug the power
cable.
2. Pull off both printhead cables (1).
3. Undo the wingscrews (2) and take off the
printhead (3).
Assembly
To assemble the device, follow the steps in the
reverse order. Make sure to do the following:
After mounting a new printhead, it is
essential to enter the printhead resistance
(SYSTEM PARAMETER > Head
off the value from the label on the printhead
(4).
Bring the printhead to the initial position
before tightening the wing screws
(standard: up to stop at inner side).
Number and position of the spacer bushings (5,
6):
Printer Spacer
left (5)
64-04/05 A0966
(9,5 mm)
64-06 A0966
(9,5 mm)
64-08 A0966
(9,5 mm)
64-xx Dispenser 2x A0967
(11,3 mm)
SERVICE MANUAL
64-xx – 64-xx Dispenser
resistance). Read
5
Spacer
right (6)
none
3
A0967
(11,3 mm)
2x A0966
(9,5 mm)
none
Service Mechanics
4
2
2
43
1
6