Table of Contents
Advertisement
03/10 Rev. 5.04-04
Assembly
To assemble the device, follow the steps in
the reverse order. Make sure to do the
following:
Mount the stop disc with the larger
chamfer pointing outwards.
Lightly grease the bearing surface of the
belt disc (6) before assembly (with
universal grease). Make sure that no
grease gets between the discs!
Mount the brake disc (5) with the sharp
edge pointing outwards.
Screw the cap and nut onto the
threaded rod till they reach the depth
noted earlier.
After the assembly: set the braking
torque.
See section
Setting the braking torque
on page 27.
Ribbon rewinding mandrel (type 2)
Tools
– 2.5/2 mm allen keys
– Size 7/8 socket wrenches
– Plastic hammer
Preparation for disassembling
1. Remove front and rear hood.
2. Remove the ribbon motor. Hang out the
toothed belt.
3. Unscrew the contact spring (1).
4. Measure and note how deep the nut (3)
and cap (2) are screwed on to the
threaded rod.
5. Remove the securing nut (3).
Continued on the next page.
SERVICE MANUAL
64-xx – 64-xx Dispenser
1
Service Mechanics
2
3
23
Advertisement
Table of Contents
