Table of Contents
Advertisement
03/10 Rev. 5.04-04
All pictures in this paragraph show a
printer with installed Full Size sensor.
Assembling the printhead brush
1. Take the printhead antistatic brush (1).
The brush provides several holes of two
sizes.
Number and position of the holes
depend on the printer type!
(Fig. right above: brush for 64-06)
2. Hold the antistatic brush (1) in front of
the printhead.
3. Remove the screws which appear
behind the smaller holes (2) of the
brush.
Don´t loosen the screws behind the
bigger holes!
4. Fix the antistatic brush at the print head,
using the screws (2) you unscrewed
before.
Assembling the brush tubes
1. Remove the front and rear hood as well
as the left front housing.
How to? – read paragraph
page 6.
2. Disassemble the print head motor.
Find a description in paragraph
head motor
on page 50.
Continue overleaf.
SERVICE MANUAL
64-xx – 64-xx Dispenser
Housing
on
Print
Service Mechanics
2
3
4
4
1
74
1
Advertisement
Table of Contents
