Table of Contents
Advertisement
1. Using InfiniiMax III Series Probes
N5477A Sampling Scope Adapter
N5477A Sampling Scope Adapter
16
The N5477A Sampling Scope Adapter allows you to connect the
InfiniiMax III probing system to the Infiniium 86100D DCA-X sampling
oscilloscope or other RF instruments.
Figure 7
N5477A InfiniiMax III Sampling Scope Adapter
Connect the NMD/3.5 mm side of the adapter to one of the channel
inputs on the sampling oscilloscope. Then connect the power cord to
either the probe power output on the DCA-X 86100D wideband
oscilloscope (if the module being used has this receptacle) or to the
1143A power module. Finally, connect the other side of the adapter to the
InfiniiMax III probe amplifier.
Previously, the DCA-X wideband oscilloscope was limited to 13 GHz of
probing, but with the N5477A sampling oscilloscope adapter, the DCA-X
can now probe up to 30 GHz.
The N5477A sampling oscilloscope adapter can also be used to connect
the InfiniiMax III probing system to generic 50 Ohm test equipment as
long as the 1143A power supply and 5062-1247 NMD male-to-3.5mm
female adapter are used. Both of these parts can be ordered through
Keysight Technologies.
Advertisement
Table of Contents
