Keysight Technologies InfiniiMax III Series User Manual page 7

C A U T I O N
DC Calibration Indicator
Channel Identification
Channel Connection
C A U T I O N
C A U T I O N
If you select the wrong pairing of ZIF probe head and ZIF probe tip in the
oscilloscope GUI's probe menu, your waveforms will look incorrect.
Indicates if the particular combination of probe amplifier, probe head, and
oscilloscope channel input is calibrated. Any time you use a new probe
head type, a new probe amplifier, or a different channel on the
oscilloscope, the DC Cal indicator turns amber, indicating that a DC
calibration is required. After performing a calibration as described in
Chapter 4, "Calibration / Deskew Procedure", the DC Cal indicator turns
green.
Use the channel-identification rings to match each probe to the color of
the oscilloscope's input channel to which it is connected. This enables you
Rings
to quickly know which probe is connected to each channel without having
to trace cables back to the oscilloscope inputs.
Refer to "Proper Handling Techniques"
to the oscilloscope.
The connector labeled A in
oscilloscope channel inputs. If connecting it directly to an Infiniium 90000
X-series oscilloscope, plug it into the channel and then turn the gray
clutch/dial around the input
disconnect the probe amplifier, loosen the clutch on the oscilloscope
input and disconnect the probe amplifier. If you are using an InfiniiMax III
probe amplifier with a Keysight sampling oscilloscope, you will need to
use the N5477A sampling scope adapter.
The connector labeled B in
InfiniiMax III probe heads.
InfiniiMax I and II probe heads are not compatible with the InfiniiMax III probe
amplifiers and vice versa.
1. Using InfiniiMax III Series Probes
InfiniiMax III Probe Amplifiers
on page 9 before connecting any probe
Figure 1 on page 6 plugs into one of the
(Figure 2 on page 8) until it clicks. To
Figure 1 on page 6 connects to one of the
7