AJAX CombiProtect User Manual page 11

CombiProtect detector can be attached to a vertical surface or in a corner.
1. Attach the SmartBracket panel to the surface using bundled screws, using
at least two xing points (one of them – above the tamper). If you select
other attachment hardware, make sure that they do not damage or deform
the panel.
The double-sided adhesive tape may only be used for temporary attachment of the
detector. The tape will run dry in the course of time, which may result in the falling
of the detector and actuation of the security system. Furthermore, the device may
fail from a hit, as a result of an impact.
2. Put the detector on the attachment panel. When the detector is xed in
SmartBracket, it will blink with an LED – this will be a signal that the tamper
on the detector is closed.
If the light indicator of the detector is not actuated after installation in
SmartBracket, check the tamper mode in the
the xing tightness of the panel.
If the detector is torn off from the surface or removed from the attachment
panel, you will receive the noti cation.
Do not install the detector:
1. outside the premises (outdoors);
Ajax Security System app and then